FOR AGRICULTURAL OR COMMERCIAL USE ONLY NOT FOR USE BY HOMEOWNERS. For Postemergent Weed Control in Sugarcane, Turf, Ornamentals, Christmas Tree Plantings and Non-Cropland ACTIVE INGREDIENT. Sodium salt of asulam (methyl sulfanilylcarbamate)........................................................... 100.0% Equivalent to 33.1% asulam or not less than 3.34 lbs.
GENERAL INSTRUCTIONS AND INFORMATION APPLICATION INSTRUCTIONS. Herbicide through any type of irrigation systems. Do not apply this product in a way that will contact workers or other persons, either directly or through drift.Only protected handlers may be in the area during application. For any requirements specific to your State or Tribe, consult the agency re- sponsible for pesticide regulations. This herbicide should only be applied when the potential for drift to adjacent sensitive areas e. Res- idential areas, bodies of water, known habitats for threatened or endangered species, non-target crops is minimal e. When wind is blowing away from the sensitive areas. AVOIDING SPRAY DRIFT AT THE APPLICATION SITE IS THE RESPONSIBILITY OF THE APPLICATOR. The interac- tion of many equipment and weather-related factors determine the potential for spray drift. The applicator is responsible for considering all these factors when making decisions.
The following drift management requirements must be followed to avoid off-target movement from aerial applications to agricultural field crops. These requirements do not apply to forestry applications, public health uses or to applications using dry formulation. The distance of the outer most nozzles on the boom must not exceed 3/4 the length of the wingspan or rotor. Nozzles must always point backward parallel with the air stream and never be pointed downwards more than 45 degrees.
Where states have more stringent regulations, they should be observed. The applicator should be familiar with and take into.
Account the information covered in the Aerial Drift Reduction Advisory Information. (This section is advisory in nature and does not supersede the mandatory label requirements) The most effective way to reduce drift potential is to apply large droplets. The best drift management strategy is to apply the largest droplets that provide sufficient coverage and control. Applying larger droplets reduces drift potential, but will not prevent drift if applications are made improperly, or under unfavorable environmental conditions (see Wind, Temperature and Humidity, and Temperature Inversions below).
(This section is advisory in nature and does not supersede the mandatory label requirements). Volume - Use high flow rate nozzles to apply the highest practical spray volume. Nozzles with higher rated flows produce larger droplets. Pressure - Do not exceed the nozzle manufacturers recommended pressures.For many nozzle types lower pressure pro- duces larger droplets. When higher flow rates are needed, use higher flow rate nozzles instead of increasing pressure. Number of nozzles - Use the minimum number of nozzles that provide uniform coverage. Nozzle Orientation - Orienting nozzles so that the spray is released parallel to the airstream produces larger droplets than other orientations and is the recommended practice.
Significant deflection from horizontal will reduce droplet size and in- crease drift potential. Nozzle Type - Use a nozzle type that is designed for the intended application. With most nozzle types, narrower spray an- gles produce larger droplets.Solid stream nozzles oriented straight back produce the largest droplets and the lowest drift. (This section is advisory in nature and does not supersede the mandatory label requirements) For some use patterns, reducing the effective boom length to less than 3/4 of the wingspan or rotor length may further re- duce drift without reducing swath width.
(This section is advisory in nature and does not supersede the mandatory label requirements) Applications should not be made at a height greater than 10 feet above the top of the target plants unless a greater height is required for aircraft safety. Making applications at the lowest height that is safe reduces exposure of droplets to evapo- ration and wind. (This section is advisory in nature and does not supersede the mandatory label requirements) When applications are made with a crosswind, the swath will be displaced downwind. Therefore, on the up and downwind edges of the field, the applicator should compensate for this displacement by adjusting the path of the aircraft upwind.Swath adjustment distance should increase, with increasing drift potential higher wind, smaller drops, etc. (This section is advisory in nature and does not supersede the mandatory label requirements) Drift potential is lowest between wind speeds of 2 to 10 mph. However, many factors, including droplet size and equipment type determine drift potential at any given speed. Application should be avoided below 2 mph due to variable wind direc- tion and high inversion potential. Local terrain can influence wind patterns.
Every applicator should be familiar with local wind patterns and how they affect spray drift. (This section is advisory in nature and does not supersede the mandatory label requirements) When making applications in low relative humidity, set up equipment to produce larger droplets to compensate for evapo- ration. Droplet evaporation is most severe when conditions are both hot and dry.
Check out my other items. The item "Asulox Herbicide (2.5 Gallon) Herbicide For Agricultural & Commercial Use" is in sale since Wednesday, March 01, 2017. This item is in the category "Home & Garden\Yard, Garden & Outdoor Living\Gardening Supplies\Weed & Pest Control\Weed Control\Herbicides & Fungicides". The seller is "happygarden685" and is located in Sarasota, Florida. This item can be shipped to United States.